DTF Printing Usage Instructions

Storage

Apply powder within 1 minute of printing to avoid ink overdrying and oiling issues.
Use Ultranex hot melt thermoplastic polyurethane (PU) adhesive powder, particle size 100µ to 200µ, after printing.

The machine’s set temperature could be between 110°C and 130°C or 230°F and 265°F, (Depends on Machine to Machine .
Dry/cure at 160°C to 180°C or 320°F for 2 to 4 minutes. (Temperature mentioned here is temperature received to the film & not the set temp. of oven.)

Cover the printed roll in a sealed plastic bag away from moisture.
For cut labels, if the relative humidity is high, place absorbent paper between each print.(This will absorb moisture from the labels in storage.)

Before transfer, if there is oil on the label, dry it by pressing with absorbent paper or heating for 1-2 minutes at 160°C or 230°F.
Transfer temperature: 140°C to 160°C, 15 to 8 seconds. Pressure: 2 to 4 bars depending on the size of the heat press. If using a manual press, ensure pressure is correct and even on all sides.
Although the Ultranex DTF film is a hot peel film, for best results, soft feel, and wash stability, peel the film after 10 seconds of transfer.
If the transfer pressure, temperature, and time are correct, repressing the transfers is not necessary. However, if you see moisture on the transferred image, wipe it off with a damp cloth or repress using parchment paper.